BRONCO SHOCK & HOOP MOUNTS

Double Shocks Double shocks are a must for all 66-77 Broncos, not just hardcore off-roaders. They're always the first improvement we make. Double shocks improve handling, braking, all-around performance and prevent wheel hop and body sway. By keeping the tires on the ground they improve cornering on pavement and dirt, and helps to control axle-wrap. Double shocks work like anti-sway bars without restricting wheel travel. We cannot overstate the importance of double shocking a Classic Bronco. The belief that double shocks are "too stiff" is just a myth. When properly valved shocks are used, they compliment properly designed springs.

Front Double Shock Mounts Classic weld-on brackets for use with our 70/30 shocks, sold separately. #5101 Ft Double Shock Mounts, 66-77 Bronco, $59.00

Rear Double Shock Mounts Designed like original stock mounts, welds on the frontside of the axle. Made of a high quality solid steel shaft machined on the end. Uses the same shock as in the original rear position. Can be used as a replacement for a stock mount. Note: Early '66 model stock mounts are stud/eye. Shocks sold separately. Minor sheetmetal trimming is necessary. #5500 Rear Double Shock Mounts, 66-77 Bronco, $55.00 New Stage 1 Rear Shock Mounts Now a version for those of you without a body lift! By utilizing angled shock mounting and removing the limiting stock mounts these new mounts will give you more travel than our Classic rear mounts and help control axle wrap more effectively. Zinc plated, bolt and weld-on design. May requires minor sheet metal trimming depending on the condition of your body mounts. Shocks sold separately. #5215 Stage 1 Rear Shock Mounts $169.00

Stage 2 Rear Shock Mounts Designed to maximize the suspension travel by removing the limiting stock shock mounts. These new mounts take advantage of the extra clearance above the frame created with a body lift. By utilizing angled shock mounting and 12" travel shocks, you get 15" of vertical travel and a reduction in axle wrap! Requires a 2 or 3" body lift and minor sheet metal trimming. Zinc plated, bolt and weld-on design. #5214 Stage 2 Rear Shock Mounts, 2-3" body lift required, 1966-77 Bronco, $169.00

Original Dual Shock Hoops Our original hoop shock mounts for 66-77 Broncos offer all the benefits of double shocks and increase front wheel travel to 9 1/2 inches! By removing the travel limiting factory shock tower we have created the ultimate setup for an all-around Bronco. The hoops use our 70/30 eye-eye shocks for a minimum of bushing wear and a maximum of performance. The hoops bolt on and utilize the same weld-on lower mount as our #5101 double shock mounts. They come zinc plated for corrosion resistance and should also be welded to the frame for additional strength. If your Bronco already has our #5101 double shock mounts, they can be bolted through the hoop and used as heavy duty braces. #5201 Dual Shock Hoops, $219.00 #5201-2 Behind The Coil Kit, $49.00

Eric Ford @ PSVB Anniversary Run, Sequim, WA 35x12.5x15 Goodyear MTR Stage 2 Long Travel Shock Hoops These hoops use our new 15" travel shocks, the longest in the Bronco market! These mounts take advantage of the extra clearance in the fender wells created with a body lift. They allow you to mount the shocks in any of three positions, one in front and two in back of the coil! Allowing your suspension to really perform without being limited by shorter shocks. Requires a 2 or 3" body lift for proper fit without inner fender modification. Some ’77 models may require inner fender mods on driver side. Zinc plated, bolt and weld-on design. #5212 Stage 2 Long Travel Hoops, 2-3" body lift required, 1966-77 Bronco, $249.50

3231 NW Park Dr., Knoxville, TN 37921 Phone: 1-865-938-6696 7am-3pm M-F West Coast 10am-6pm M-F East Coast Fax: 1-865-938-6746 24 Hours